|
INCLUDED with Standard Installation
|
NOT INCLUDED with Standard Installation
|
Mount
the dish to an approved structure at least five feet off the ground as
required by FCC regulations, using HUGHES standard roof, and/or wall
mounting brackets.
Mount to a one-story surface. |
Complex/custom installations that may result in
additional fees.
-
Make sure you discuss
any custom work with your installer before they begin the job.
|
|
Install a coaxial cable jack in the room where the
HughesNet System will be located. |
Custom work including, but not limited to:
-
Moldings or cosmetic
hardware to help hide cables
-
Non-penetrating roof,
pole, or chimney mounts
-
Wall Fish Wires
-
Attic or Crawl Space Crawl
|
|
Route two exterior RG-6 coaxial cables (each up to 100
feet in length) from the dish into the house, and to the coaxial cable
jack. |
Installation of DIRECTV® receivers and cables
and/or complex connections to stereo/audio components. |
|
Provide and install the hardware required to properly
ground your HughesNet System. |
Driving distances of over 15 miles to the job. |
|
Install the HughesNet modem and connect them to your PC. |
Removal and/or repair of previously mounted equipment (a
signed Waiver of Liability must be included to perform this work). |
|
Verify receipt of satellite signal. |
Mounting to a roof surface that exceeds one story in
height |
|
Commission your HughesNet account. |
Non-penetrating roof mount, pole mount, or chimney mount. |